浸滲液根據使用的需求不同，我們可以使用不同的浸滲液，它們分為有機浸滲和無機浸滲，關于這兩種分類大家了解多少呢？下面就讓我們浸滲液廠家來為大家詳細的介紹一下吧。

一、無機浸滲

是比較古老的浸滲方法,其浸滲液主要由水玻璃（硅酸鹽+結晶水）構成,類似于日常生活中使用的水泥.

它的成分決定了它對人體的傷害,由于自帶約百分之50的結晶水,故從100攝氏度不到的水域中散發出來的蒸汽,大部分以結晶水為主,即為純水。

二、有機浸滲

是新的浸滲方法,對于壓鑄件,尤其是鋁合金壓鑄件的封孔十分好.

但同時,由于有機浸滲液的主要成分是有機化合物甲基丙烯酸酯類,類似于AB膠的主要成分.所以,蒸汽中會帶有這種成分,人體吸入后有一定危害.建議操作時（打開固化罐的時候）,務必帶好口罩,護眼罩等工具。

經過以上浸滲液廠家的介紹，現在大家應該對于這方面的知識有了明確的了解了吧。

Leachate according to different needs, we can use different leachate, they are divided into organic leachate and inorganic leachate, how much do you know about these two categories? Let us soak the ooze factory to introduce it in detail.

First, inorganic infiltration

Is a relatively old infiltration method, the leaching liquid is mainly composed of sodium silicate (silicate + water of crystal), similar to the daily use of cement.

Its composition determines its harm to the human body, because it comes with about 50 percent of the water of crystal, so from the water less than 100 degrees Celsius vapor, most of the main crystal water, that is, pure water.

Two, organic infiltration

Is a new infiltration method, for die casting, especially aluminum alloy die casting hole sealing is very good.

But at the same time, because the main components of organic leaching solution is organic compound methacrylate, similar to the main components of AB glue. Therefore, steam with this component, human inhalation after a certain harm. It is recommended that when operating (when opening the curing tank), be sure to wear masks, eye shields and other tools.

After the introduction of the above immersion liquid manufacturers, now you should have a clear understanding of this knowledge.